|
The Phantom X1 is a single-engined, tractor configuration, single seat, cable-braced high wing tricycle gear-equipped ultralight aircraft that is produced by Phantom Aeronautics of Three Rivers, Michigan and available in kit form.〔Cliche, Andre: ''Ultralight Aircraft Shopper's Guide'' 8th Edition, pages B-45, B-93 and E-33. Cybair Limited Publishing, 2001. ISBN 0-9680628-1-4〕〔Downey, Julia: ''1999 Kit Aircraft Directory'', Kitplanes, Volume 15, Number 12, December 1998, page 61. Primedia Publications. ISSN 0891-1851〕〔Purdy, Don: ''AeroCrafter - Homebuilt Aircraft Sourcebook'', page 221. BAI Communications. ISBN 0-9636409-4-1〕 The X1 design was intended to have an empty weight under to fit into the FAR Part 103 ultralight category. There is also an X2 two seater which was designed as an ultralight trainer. Modernized models of the single and two-seaters use struts in place of the original cable-bracing.〔〔〔 ==Design and development== The Phantom X1 was introduced at Sun 'n Fun in 1982, where it attracted a great deal of attention and won a major design award. The design was produced by a number of different manufacturers, including Phantom Aircraft of Kalamazoo, Michigan and has been widely copied. Derivative designs include the Bell Sidewinder, Hy-Tek Hurricane 103, Worldwide Ultralite Spitfire and the Golden Gate Mosquito.〔 The Phantom X1 is constructed from bolted-together aluminum tubing. The wings and tail surfaces are covered in Dacron sailcloth in the form of pre-sewn envelopes. The wings are wire-braced from an inverted "V" shaped kingpost and feature full-span ailerons. There was also a factory option offered to allow the wings to fold for transport and storage. The engine is mounted on the front of the main tube, the tail being mounted on the far end of the same tube. The cockpit pod is made from fiberglass. The landing gear includes a steerable nosewheel.〔 The X1 was originally designed as an aerobatic aircraft and was tested to +9/-6.6 g before failure and carries operational limits of +6.6/-4.4 g. The full-span ailerons also give the X1 a fast roll-rate. For liability reasons the X1 was never marketed as an aerobatic design.〔 Factory options included brakes and a complete airframe parachute along with a variety of Rotax engines from . Original assembly time was rated by the manufacturer as 40 hours.〔〔 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Phantom X1」の詳細全文を読む スポンサード リンク
|